NTSB Meeting June 18 to Determine Cause of 2017 School Bus Fire

NTSB board members will determine the probable cause of an incident that killed a 74-year-old school bus driver and a 16-year-old student passenger when the bus caught fire near Oakland, Iowa, on Dec. 12, 2017.

The National Transportation Safety Board has announced a June 18 meeting where board members will determine the probable cause of an incident that killed a 74-year-old school bus driver and a 16-year-old student passenger when the bus caught fire near Oakland, Iowa. The fire occurred about 6:50 a.m. on Dec. 12, 2017.

According to NTSB's preliminary report, the driver of the 2004 International school bus turned into a driveway and picked up his first passenger, the 16-year-old student. As the bus backed out of the driveway, its right rear tandem wheels crossed a 3-foot-wide earthen strip adjacent to the road and dropped into a 3-foot-deep ditch. "Although still in contact with the ground, the right rear drive wheels lost traction, and the bus became stuck with about half of the vehicle positioned across the gravel roadway. The driver attempted to move the bus forward out of the ditch. As he was doing so, a fire began in the engine compartment and spread into the passenger compartment. Sometime during this event, the grass and vegetation at the rear of the school bus also caught fire," the report states. "For unknown reasons, the driver and student passenger did not exit the school bus. Both occupants died as a result of the fire."

The school bus was owned and operated by the Riverside Community School District. It went into service in 2005. NTSB investigators found the bus had potentially been subject to four recall campaigns, and the agency determined that three of the recalls applied to the bus, while the fourth recall, addressing a power steering pump failure that could cause a fire, did not apply to this specific bus model. The three applicable recalls were designed to correct issues with a sensor used in the antilock brake system, a sensor used in the side-mounted swing-out stop arm, and the wiring harness to the stepwell heater blower motor. The agency's investigators did confirm that the three recalls were performed.

The bus was equipped with a continuous onboard video recording system, but it was severely damaged by the fire. The report states that the NTSB Recorders Laboratory determined there were no recoverable data.

Download Center

HTML - No Current Item Deck
  • Get the Ultimate Guide to OSHA Recordkeeping

    OSHA’s Form 300A posting deadline is February 1! Are you prepared? To help answer your key recordkeeping questions, IndustrySafe put together this guide with critical compliance information.

  • Steps to Conduct a JSA

    We've put together a comprehensive step-by-step guide to help you perform a job safety analysis (JSA), which includes a pre-built, JSA checklist and template, steps of a JSA, list of potential job hazards, and an overview of hazard control hierarchy.

  • Everything You Need to Know about Incident investigations

    Need some tips for conducting an incident investigation at work after there’s been an occupational injury or illness, or maybe even a near miss? This guide presents a comprehensive overview of methods of performing incident investigations to lead you through your next steps.

  • Free Safety Management Software Demo

    IndustrySafe Safety Management Software helps organizations to improve safety by providing a comprehensive toolset of software modules to help businesses identify trouble spots; reduce claims, lost days, OSHA fines; and more.

  • Industry Safe

OH&S Digital Edition

  • OHS Magazine Digital Edition - November December 2020

    November December 2020

    Featuring:

    • COLD STRESS
      Managing Cold Stress
    • TRAINING: FALL PROTECTION
      Providing Training for Fall Protection
    • PPE: HEARING PROTECTION
      Eight Tips for Hearing Testing Day
    • FACILITY SECURITY
      Incorporating COVID-19 Protections into Safety Programs
    View This Issue