Articles


Real effort is needed to reduce your monthly disposal expenses and stem long range expenses from "down the crack." Using adequate spill containment is the key. (Trans Environmental Systems, Inc. photo)

Are Your Future Profits Going 'Down the Crack'?

Little "ooops!" add up to big future problems.

Alstom

OSHA Cites Railcar Manufacturer for Hazardous Exposures

The agency has issued 17 serious violations and $105,000 in penalties for exposures at Alstom's Hornell, N.Y., plant.

Agencies Working to Stop Spread of Colistin-Resistant Gene

CDC and HHS are involved. The Department of Defense notified stakeholders this week that its Multidrug-resistant Organism Repository and Surveillance Network at the Walter Reed Institute of Research had identified the first colistin-resistant mcr-1 E. coli in a person in the United States.

Workers Exposed to Chemical Hazards at Fragrance Manufacturer

OSHA has issued one repeat, six serious, and one other-than-serious violation.

The 'Deadliest Catch' No More

Efforts by the fishing industry, Coast Guard, and National Marine Fisheries Service have all contributed to the fleet's improved safety.

By continually raising awareness of the AED program, organizations reinforce a commitment to safety among employees. (American Heart Association photo)

Working Against Time: Nine Steps to Implementing a Successful AED Program

Setting up an AED program takes planning but is not difficult. Here are the key steps to implementing one within the workplace.

Yoga classes were the top wellness activity for incentives, and 41 percent of the survey

Keys to Employee Engagement

Yoga classes were the top wellness activity for incentives, and 41 percent of the MeetingsNet/IRF survey’s respondents said they consciously build wellness opportunities into their agendas.

Some are not aware that state-level Good Samaritan protections have advanced considerably over the years.

CPR and AEDs—Two Important Acronyms for Your Workplace First Aid Program

There are still scenarios where the AHA strictly recommends conventional CPR.



The final rule incorporates all or designated portions of several industry standards, including the American Petroleum Institute’s Standard 53, Blowout Prevention Equipment Systems for Drilling Wells, Fourth Edition.

Weighing BSEE's Well Control Rule

While Director Brian Salerno calls it "one of the most comprehensive offshore safety and environmental protection rules ever developed by the Department of the Interior," one industry group said the rule "could result in unintended negative consequences leading to reduced safety, less environmental protection, fewer American jobs, and decreased U.S. oil and natural gas production."

New ASSE Executive Director Welcomes the Challenge

"The board has made it clear it wants ASSE to improve service to our current members and attract new ones, bolster the educational outreach available through our professional development offerings, become a leader in developing OSH standards, and elevate the value of the profession within the business community," said Dennis Hudson, whose appointment is effective June 1. "It's a tall order, but with all 72 employees working together, ASSE will be better and stronger than ever."

Vendors and health care employees are at risk when unfamiliar with techniques and procedures required to properly handle materials that can be supporting dangerous fungi and bacteria.

Three Steps to Minimize the Risk of HAIs in Your Facility

Despite CDC recommendations, there is no law requiring infection prevention training for any construction worker or other vendor working in a health care facility.

The Georgia World Congress Center hosts Safety 2016, the American Society of Safety Engineers

Dateline Atlanta

For those who attended the 2015 National Safety Council Congress & Expo nine months ago, the facility’s layout and downtown Atlanta are familiar territory.

Recognition is important in hard times, where it is not uncommon for compensation to be cut or become unexpectedly static.

Strategic Planning in Hard Times: Why Safety Incentive Programs Are a Budget Trimming Tool

Here are a few responses that will help keep the red pen away from your program.

When using PPE, whether it

Use PPE in the Workplace and Keep Your 'Eyes' on the Prize

Next is the concern that PPE is unattractive or doesn't fit properly. If employees are content with their appearance, they will be more likely to use PPE.

Employers should consider the most likely types of injuries for the site when assembling first aid supplies. In hot working conditions, this would include supplies to treat heat-related illnesses. (J.J. Keller & Associates photo)

It's Not Just the Heat—How OSHA Enforces Occupational Exposures to Hot Environments

If an employee needs medical treatment for heat stress, you would mark that as an illness on the OSHA 300 Log.

Because of the synergistic effect of many chemicals with noise, wearing a respirator and hearing protection together is an ideal defense against hearing loss whenever chemicals and noise are simultaneously present. (Honeywell Industrial Safety photo)

Can Industrial Chemical Exposure Cause Hearing Loss?

It is important to remember that any chemical that is ototoxic is also likely to be poisonous to the kidneys, because the inner ear and the kidneys arise from the same germ layer during embryonic development.

Whenever heat stress has escalated to heat exhaustion, medical services should be called and on-site cooling of the person should immediately begin. Heat stroke can occur suddenly, without any symptoms of heat exhaustion.

Understanding the Ramifications of Heat in Work Environments

Non-weather dependent hot work environments are created by the heat generated and/or contained within the environment, due to the task being performed, or both.

Companies that are committed to doing things right will do so even in down business cycles, rather than abandoning these projects during downturns.

Reducing Electrical Hazards

When safety becomes one of the design criteria for a project, it's a much more economical approach for that customer or company.

While it can be stressful to be in the middle of an unsettled industry, safety professionals are encouraging their teams by reminding them that those still working represent the best of the industry. (Cestusline, Inc. photo)

Seven Ways to Go Back to Basics With Your Safety Program

Using effective control factors to streamline PPE selection and simplify conformity across sites has the full attention of today’s safety managers.

Boomeranging: Five Methods For Revitalizing an Aging Workforce

Wise companies have attempted many strategies for mitigating the drag-down effects of older workers while trying to maximize their strengths.

Product Showcase

  • Magid® D-ROC® GPD412 21G Ultra-Thin Polyurethane Palm Coated Work Gloves

    Magid’s 21G line is more than just a 21-gauge glove, it’s a revolutionary knitting technology paired with an advanced selection of innovative fibers to create the ultimate in lightweight cut protection. The latest offering in our 21G line provides ANSI A4 cut resistance with unparalleled dexterity and extreme comfort that no other 21-gauge glove on the market can offer! Read More

  • HAZ LO HEADLAMPS

    With alkaline or rechargeable options, these safety rated, Class 1, Div. 1 Headlamps provide long runtime with both spot and flood options in the same light. Work safely and avoid trip hazards with flexible hands-free lighting from Streamlight. Read More

  • Safety Knives

    The Safety Knife Company has developed a quality range of safety knives for all industries. Designed so that fingers cannot get to the blades, these knives will safely cut through cardboard, tape, strapping, shrink or plastic wrap or a variety of other packing materials. Because these knives have no exposed blades and only cut cardboard deep, they will not only protect employees against lacerations but they will also save product. The Metal Detectable versions have revolutionary metal detectable polypropylene knife bodies specifically for the food and pharmaceutical industries. This material can be detected and rejected by typical detection machines and is X-ray visible. Read More

Featured

Artificial Intelligence

Webinars