PPE


A house in Snow Hill, N.C. lay in ruins after a tornado April 16. (Photo: David Fine/FEMA)

After the Tornadoes

The safety training you do today has a very long lifespan.

The enclosed-toe, all-rubber safety overshoe is a high-quality alternative to expensive safety footwear. (U.S. Safety photo)

Steel-Toed Assist

Revolutionary rubber safety overshoes. Try saying that fast three times.

Slew of Safety Hazards Add Up to $72,000 in Fines for Arizona Firm

Seventeen serious violations include the company's failure to ensure exits were unblocked, provide eye protection approved by the American National Standards Institute, and provide written energy source lockout/tagout procedures.

WISHA Issues Summer Safety Work Tips

Those working outdoors may have to cope with warm weather, workers who drive for their jobs may need to watch for an increasing number of pedestrians, and amusement parks must ensure workers are safe when erecting new rides or operating and maintaining rides.

Mattress Maker Hit with $45,850 in Fines for Electrical Hazards

Electrical hazards include a damaged flexible metal conduit, electrical panel boxes with unclosed openings, an electrical box with a missing blank, and an electrical conduit that was crushed and pulled apart.

Fall, Struck-By Hazards Add Up to $155,800 in Fines for Roofing Firm

In December 2010, OSHA began its inspection at the Cumberland Mall in Atlanta after Peach State Roofing employees were observed exposed to a fall hazard while working along the edge of a flat roof.

Can Denver's Safety 2012 Measure Up?

Industrial hygienists saw the Mile High City's expanded convention center last year. It is the site of ASSE's annual conference next June.

ASSE's Safety 2011 Thrives in Windy City

With more than 500 exhibitors on hand, all simultaneously vying for attention -- and with a recordbreaking number of attendees on the receiving end of that vying -- this year's show was especially bustling. Here are just a few of the sights, sounds, and goods that grabbed our attention.



This photo shows the Aquatics Centre under construction.

London 2012's 'Big Build' Nearly Done

Construction of venues is ahead of schedule, and the accident rate is below the construction industry norm, according to Stephen Williams, HSE director for the 2012 games.

Fire department needs have declined the most in the areas of PPE and firefighting equipment, according to the third NFPA assessment.

Fire Service Grants' Impact Measured

NFPA's latest needs assessment found equipment and training shortages remain, but in fewer departments, because of the Assistance to Firefighters Grant programs.

Lighting Expert Receives 2011 John Jenkins Award

CSA Standards has recognized Alex Milne for his work on lighting standards, electrical safety standards, and the Canadian Electrical Code Parts I and II.

W.Va. Firm Fined $154,000 Following Deaths of Three Workers in Explosion

"This tragedy could have been prevented," said Assistant Secretary of Labor for OSHA Dr. David Michaels. "It is imperative that employers take steps to eliminate hazards and provide a safe working environment."

This ballistic body armor is Galls by Point Blank SE Body Armor Threat Level IIIA.

Workshops Announced on Helmet, Body Armor Standards

The standards that are being revised cover two types of protective equipment for law enforcement.

Chicago ran short of hotel rooms as the ASSE Safety 2011 expo opened on June 12.

Safety 2011: Chicago Runs Short of Hotel Rooms

Record attendance at the ASSE conference and expo coincided with several events in Chicago to make hotel rooms scarce in the Second City.

Three N.Y. Contractors Fined $116,312 Following Fatal Wall Collapse

OSHA's investigation found that at the time of the incident, employees were filling an 18-foot-high by 65-foot-long concrete block wall with cement when the wall collapsed, killing one employee and hospitalizing three others.

$243,360 in Fines Issued to Maine Contractor for Fall Hazards

OSHA inspectors found four Lessard employees exposed to potentially life-threatening falls of 23 feet while working without fall protection on a steep-pitched roof at a work site in Lewiston, Maine.

Sawing masonry pieces with portable masonry saws was identified as among the most hazardous tasks.

IRSST Finds Tunnel Drillers at Highest Silica Risk

The Montreal research agency's database identified a group of skilled workers that includes bricklayers and heavy equipment operators as the second group exposed.

Methylene Chloride Exposure Leads to Firm's $49,000 Penalty

"Methylene chloride exposure can have very serious health effects, such as cancer and cardiac distress," said Paula Dixon-Roderick, director of OSHA's area office in Marlton, N.J.

New NIOSH Fact Sheet Highlights Trenching Safety

From 2000−2009, 350 workers died in trenching or excavation cave-ins—an av¬erage of 35 fatalities per year.

Donning, Doffing Decision Still Debated

A trade association and the U.S. Labor Department offered very different interpretations of the U.S. Supreme Court's 2005 decision in IBP, Inc. v. Alvarez when they commented on its application to FSIS inspectors.

Product Showcase

  • Kestrel 5400 Heat Stress Tracker WBGT Monitoring for Workplace Safety

    Ensure safety with the Kestrel® 5400 Heat Stress Tracker, the go-to choice for safety professionals and endorsed by the Heat Safety & Performance Coalition. This robust, waterless WBGT meter is ideal for both indoor and outdoor environments, offering advanced monitoring and data logging essential for OSHA compliance. It features pre-programmed ACGIH guidelines and alert settings to quickly signal critical conditions. Integrated with the cloud-based Ambient Weather Network, the 5400 allows managers to view, track, and log job site conditions remotely, ensuring constant awareness of potential hazards. Its capability for real-time mobile alerts and remote data access promotes proactive safety management and workplace protection, solidifying its role as a crucial tool in industrial hygiene. Read More

  • SwabTek® Cannabis Test Kit

    The SwabTek® Cannabis Test Kit is a single-use spot test designed for use in screening for cannabis compounds in any sample type or on any surface. The test is capable of identifying the presumed presence of cannabinoids in very small quantities, with a level of detection as little as 6 μg in mass. Learn more about the SwabTek® Cannabis Test Kit and the rest of SwabTek surface drug testing solutions through the webinar titled "Everything You Want To Know About Surface Testing" Read More

  • Glove Guard® Clip

    Safety should never be compromised, especially when it comes to proper glove usage. The Glove Guard® clip enhances safety by encouraging employees to keep their gloves with them at all times. This reduces the risk of accidents and injuries on the job. By ensuring everyone has their gloves readily available, we help promote a culture of safety and efficiency. The Glove Guard® clip is designed to withstand the toughest work environments. Constructed from robust materials made in the USA, it can endure extreme conditions, including harsh weather, and rigorous activities. Read More

Featured

Artificial Intelligence