NIOSH Releases Materials on Call Center Noise Hazards

NIOSH research shows that workers at call and dispatch centers may face several hazards, including acoustic trauma from a sudden spike in noise levels and background noise from an incoming call.

Workers at call and dispatch centers may suffer health risks associated with high noise levels from their headsets. The National Institute for Occupational Safety and Health (NIOSH) has developed recommendations for prevention.

Millions of workers at call and dispatch centers in the United States use headsets during most of their workday. They mainly include dispatchers, medical transcriptionists, air traffic control specialists, customer service representatives, switchboard operators, reservationists, and bill collectors. Many work in high-pressure, stressful environments with noisy surroundings and poor ergonomic conditions. Although these other factors can pose additional health risks to workers, the scope of this document is limited to providing recommendations for reducing noise hazards.

NIOSH research shows that workers at call and dispatch centers may face several hazards:

  • Acoustic trauma from a sudden spike in noise levels (e.g., from feedback into the headsets or a sudden change in volume),
  • background noise from the incoming call, and
  • background noise and other stressors in the workplace.

Background noise in the workplace (radios played by other workers, conversations, noise from heating and air conditioning systems) or from the callers’ locations may cause workers to turn up the headset volume, resulting in sudden increase in noise levels transmitted into their ears. Some communication systems may experience feedback or interference that could cause spikes or squeals from the headset. Some workers complain of fluctuations in noise levels in the headset or having little control over headset volume.

The NIOSH recommended exposure limit (REL) for occupational noise exposures is 85 decibels. Exposures at or above this level are considered hazardous.

NIOSH has conducted several Health Hazard Evaluations (HHE) on workers who wear headsets for most of the workday, including FAA air traffic control specialists, emergency call center operators, and police station dispatchers. NIOSH has also conducted evaluations at several locations where medical transcriptionists work and at one fire department where emergency dispatchers work. Researchers interviewed workers, measured workers’ noise exposures, conducted area noise measurements, and measured sound levels from headsets using an artificial head fixture.

With the medical transcriptionists, the sound levels of the transcription recordings often varied even within a single dictation, forcing the transcriptionists to manually adjust the volume higher or lower. In some instances, the transcriptionists adjusted the volume to a higher or maximum setting to hear a low or quiet dictation, then the dictation levels or background noise spiked suddenly and was transmitted into their ears at those maximum levels. Researchers found that sound levels and high-frequency tones played at maximum volume resulted in equivalent sound levels under the headsets that were 4-18 dBA higher than the NIOSH recommended limit of 85 dBA. Thirteen of 21 transcriptionists (62 percent) interviewed reported having problems with the fluctuation in sound levels from the transcription communication equipment and headsets.

As for the 911 fire department dispatchers, background noise in the work area did not exceed the NIOSH REL (The median value of overall full-shift noise levels was 60 dBA). However, noise from loud alarms, visitors, and other distractions did cause the dispatchers to increase the volume on their headsets to mask the noisy environment. Although an examination of actual 911 recordings played through the headsets produced peak levels as high as 100 dB SPL at maximum volume, a review of the dispatchers’ audiograms showed no evidence of noise-induced hearing loss. How¬ever, repeated and prolonged exposure to such levels can cause hearing loss and ringing in the ear.

Overall, the NIOSH evaluations did not reveal hearing loss problems among call center operators and dispatchers that can be directly attributed to noise exposures from their headsets or the surrounding environment. However, most workers interviewed reported various symptoms often associated with prolonged exposure to high noise levels. Symptoms included ringing in their ears, headaches, irritability, increased tension, and fatigue.

NIOSH recommends that workers and employers at call centers take the following steps to protect against hearing damage and other adverse health effects:

Workers

  • Notify your supervisor and take protective action if you experience tinnitus (ringing in the ears), a dulled sense of hearing, or a fullness in the ears after a work shift or exposure to noise (that was not present before the exposure or work shift). This indicates an overexposure that, if repeated, will likely cause permanent effects.
  • Do not set the volume control above the middle point. The lower the better.
  • Ask to try different headsets with improved protection or noise-cancelling features.
  • Clean and maintain your headset periodically. Replace them when you notice damage or decreased performance.
  • Take advantage of breaks (in quiet areas) whenever possible.

Employers

  • Consider supplying communication systems with noise-limiting features.
  • Install noise controls to reduce background noise levels in the work environment, such as barriers between workstations or sound-absorbing materials on hard surfaces in the room.
  • Provide workers with a variety of communication headsets that offer adjustable volume controls, noise-limiting or cancelling features, and improved comfort and protection from ambient noise.
  • Establish a regular training program and educate workers about the proper use of headsets, communication equipment, and maintaining a quiet workplace environment.
  • Evaluate workplace exposure for noise levels above the NIOSH REL of 85 dBA and establish a hearing conservation program for exposed workers, including yearly hearing tests.

Click here to read the entire fact sheet.

Product Showcase

  • Preventative Heat Safety

    Dehydration and heat exposure impair physical and cognitive performance. Proper hydration boosts heat stress resilience, but hydration needs are highly individualized and hard to predict across a workforce. Connected Hydration® empowers industrial athletes to stay safe through behavioral interventions, informed by sports science, and equips safety teams with critical insights to anticipate high-risk situations and adapt to evolving environmental factors. Curious about applying the latest in sports science based hydration strategies for industrial athletes? Stop by booth #1112 at AIHA or schedule a free demo today at https://epcr.cc/demo. Read More

  • Matrix's OmniPro Vision AI Collision Avoidance System

    OmniPro Vision AI is a state-of-the-art collision avoidance system that features NIOSH award-winning Visual Artificial Intelligence (AI) technology. This highly accurate, powerful system identifies and alerts on pedestrians, vehicles and specified objects, ensuring safer facilities, mining operations and industrial sites. With its web-based cloud application, OmniPro Vision AI also logs and analyzes a wide range of data related to zone breach notifications. Operating without needing personal wearable devices or tags, OmniPro has visual and audible zone breach alerts for both operators and pedestrians. Read More

  • Safety Knives

    The Safety Knife Company has developed a quality range of safety knives for all industries. Designed so that fingers cannot get to the blades, these knives will safely cut through cardboard, tape, strapping, shrink or plastic wrap or a variety of other packing materials. Because these knives have no exposed blades and only cut cardboard deep, they will not only protect employees against lacerations but they will also save product. The Metal Detectable versions have revolutionary metal detectable polypropylene knife bodies specifically for the food and pharmaceutical industries. This material can be detected and rejected by typical detection machines and is X-ray visible. Read More

Featured

Artificial Intelligence